Installing Hard Drives Into The Drive Trays; Installing Hard Drives; Configuring The Storage Module; Storage Module Options - Advantech HPC-7480 User Manual

2.5

Installing Hard Drives into the Drive Trays

2.5.1

Installing Hard Drives

1. Remove the screws from the hard drive tray and set them aside for later use.
2. Remove the dummy drive from the hard drive tray.
3. Mount a hard drive into the hard drive tray
4. Replace the screws which were set aside earlier.
5. Install the hard drive into the chassis.
6. Push down the release tab over the newly installed hard drive.
7. Close the hard drive tray door.
2.6

Configuring the Storage Module

2.6.1

Storage Module Options

The storage module can configured to accommodate a variety of data storage
devices such as CD, IDE, DVD, tape and floppy drives. The chassis may be rotated
from a vertical tower position, to a horizontal rack mounting position to accommodate
use of these devices. The following configurations may be used in the HPC-7480
chassis:

5.25" Drives: Install any combination of three 5.25" devices.
HPC-7480 User Manual
1
8
1
7
1
9
1
6
Figure 2.3 Removing Hard Drive Trays
2
1
Removing the Dummy Drive
Figure 2.4 Hard Drive Trays
1
4
3
1
Installing the Hard Drive
8