Installing Or Removing The Flash Memory Card (Optional); Verifying Package Contents - Cisco IE-4000-4TC4G-E Hardware Installation Manual

Installing or Removing the Flash Memory Card (Optional)

Verifying Package Contents

If any item is missing or damaged, contact your Cisco representative or reseller for support.
Installing or Removing the Flash Memory Card (Optional)
The software/firmware is stored on the SD card memory from factory default. Optionally, you can
execute the sync command to copy the software/firmware (including directory) to on-board memory
(flash memory), then remove the SD card. it is strongly recommended that you use the SD card to boot
or store the config for future easy replacement, in case of a hardware failure.
Do not insert or remove the flash card while power is on; an electrical arc can occur. This could
Warning
cause an explosion in hazardous location installations. Be sure that power is removed or the area
is nonhazardous before proceeding. Statement 379
To install or replace the flash memory card, follow these steps:
On the front of the switch, locate the door that protects the flash memory card slot. Loosen the captive
Step 1
screw at the top of the door using a Phillips screwdriver to open the door. See
Figure 2-1
Install or remove the card:
Step 2
•
•
Cisco IE 4000 Switch Hardware Installation Guide
2-6
Installing the Flash Memory Card in the Switch
To install a card, slide it into the slot, and press it in until it clicks in place. The card is keyed so that
you cannot insert it the wrong way.
To remove the card, push it in until it releases for it to pop out. Place it in an antistatic bag to protect
it from static discharge.
Chapter 2 Switch Installation
Figure 2-1.