Configuring the Switch with the CLI-Based
Setup Program
This appendix provides a command-line interface (CLI)-based setup procedure for a switch.
Before connecting the switch to a power source, review the safety warnings in
For installation procedures, see
Accessing the CLI Through the Console Port
You can enter Cisco IOS commands and parameters through the CLI. Use one of these options to access
the CLI:
•
•
Removing the USB Mini-Type B Console Port Cover
To remove the cover from the USB mini-type B console port:
Use a Philips screwdriver to loosen the captive screw on the USB mini-type B console port cover. See
Step 1
See
RJ-45 Console Port
USB Mini-Type B Console Port
Figure
A-1. Remove the screw and take off the cover.
A P P E N D I X
Chapter 2, "Switch Installation."
Cisco IE 4000 Switch Hardware Installation Guide
A
Warnings, page 2-2
A-1