Installing The Switch On A Din Rail - Cisco IE-4000-4TC4G-E Hardware Installation Manual

Installing the Switch
To prevent the switch from overheating, ensure these minimum clearances:
Caution
– Top and bottom: 2.0 in. (50.8 mm)
– Exposed side (not connected to the module): 2.0 in. (50.8 mm)
– Front: 2.0 in. (50.8 mm)

Installing the Switch on a DIN Rail

The switch ships with a spring-loaded latch on the rear panel for a mounting on a DIN rail.
You can install the switch as a standalone device on the DIN rail or with the expansion modules already
connected. You must connect expansion modules to the switch before installing the switch on the DIN
rail.
To attach the switch to a DIN rail, follow these steps:
Position the rear panel of the switch directly in front of the DIN rail, making sure that the DIN rail fits
Step 1
in the space between the two hooks near the top of the switch and the spring-loaded latch near the
bottom.
Holding the bottom of the switch away from the DIN rail, place the two hooks on the back of the switch
Step 2
over the top of the DIN rail. See
Do not stack any equipment on the switch.
Caution
Figure 2-9
1
Cisco IE 4000 Switch Hardware Installation Guide
2-20
Position the Hooks Over the DIN Rail
1
DIN Rail 2 Switch
Figure 2-9.
2
Chapter 2 Switch Installation