How To Control The Unit; Dmx Channel Mode - ACME LED-BL4B User Manual

5. How To Control The Unit

5.1 Two ways to operate the unit:
1. By master/slave
2. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting
will be affected at once. Turn on the unit, under the DMX signal , the LED will display the
saved channel address（001-512）; If without DMX signal,
The master will show SH00-SH12(Chase Mode )、STRO(Strobe Mode) or DIM (Dimming
Mode ),the slave will show SL00-SL01; If there is something wrong in the temperature
checkout console or the temperature over high/low, the LED will display TERR, and the unit
will flash (light on /light off) in a very low brightness continually. The master/slave on line can
use easy controller CA-8 to control the master to change the mode (Sound active Chase、
Chase automatically、Strobe and Dimming )
5.2 Easy controller (by CA-8)
The easy remote control is used only in master/slave mode. By connecting to the first master
unit, you will find that the remote controller on the first unit will control all the other units for
Standby, Function and Mode selection
Blackout the unit (the LED indicator will light on/off
STAND BY
accordingly)
1. Short Enter can be shifted Synchronous Strobe/Random
Strobe/ sound Strobe； （Mode1）
FUNCTION
2. Change the SHOW effect (0-12)； （Mode2）
3. Change the lightness； （Mode3）
1， Run the SHOW by sound (LED indicator off)； （default
MODE
2， Run the SHOW by auto. (LED indicator flash)；
3，Dimming（LED indicator on） ；
mode）;
10B
6.
DMX512
Channel
Mode