ACME LED-BL4B User Manual page 4

 Please unpack and check carefully there is no transportation damage before using the
fixture.
 Please disconnect main power before servicing and maintenance.
 The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
 The maximum ambient temperature is Ta: 40℃. DO NOT operate it where the
temperature is higher than this.
 DO NOT connect the device to any dimmer pack.
 The housing must be replaced if they are visibly damaged.
 Unit surface temperature may reach up to 85℃. Don't touch the housing bare-hand
during its operation. Turn off the power and allow about 15 minutes for the unit to cool
down before replacing or serving.
 There are no user serviceable parts inside the fixture. Do not open the housing or attempt
any repairs by yourself. In the unlikely event your fixture may require service, please
contact your nearest dealer.
 In the event of serious operating problem, stop using the fixture immediately. Never try to
repair the fixture by yourself. Repairs carried out by unskilled people can lead to damage
or malfunction. Please contact the nearest authorized technical assistance center. Always
use the same type spare parts.
It's important to ground the yellow/green conductor to earth in order to avoid

electric shock.
 DO NOT touch any wire during operation and there might be a hazard of electric shock.
DO NOT expose the fixture to rain or moisture, in order too prevent or reduce

the risk of electrical shock or fire.
Do not look directly at the LED light beam while the fixture is on.

3B