GIRBAU RMS610 Operating Instructions Manual page 6

18. All installations required for the proper operation of the machine MUST be carried out by a duly accredited
Registered Installation Contractors (see Note 3), in compliance with the legal regulations applicable in the
country of use.
19. The machine MUST be commissioned by the Authorised Technical Service in the presence of the
Customer Technical Service (see Notes 2 and 4) or a responsible person appointed by the customer.
20. This machine MUST BE USED by personnel who are properly trained in how to use it (see Note 1).
21. NEVER START THE MACHINE, OR USE IT, IF THE FOLLOWING ARE ABSENT, INCORRECTLY
POSITIONED OR MALFUNCTIONING:
 COVERS (GUARDS) AND PROTECTIVE DEVICES
 SAFETY DEVICES
 CONTROL ELEMENTS
22. DO NOT USE the machine if you notice any abnormal noise or smell or if you suspect that the machine is
faulty or defective.
23. The inspections required by the regulations applicable to the country where the machine is being used
must be carried out. It is advisable to request an overall, detailed service of the machine by the Authorised
Technical Service every year (see Note 2).
24. WARNING!
INSPECTION, MAINTENANCE OR REPAIR OPERATIONS
Before carrying out any action on the machine:
 Close and mechanically lock the manual fluid supply valves.
 Check that the bath has COMPLETELY drained, that no part of the machine is at a high temperature
and that no circuits or containers are under pressure.
 Check that all the machine's moving parts are halted or in their rest position. Securely fix all the
machine's moving parts that could cause an accident.
To reduce the risk of electric shock:
 COMPLETELY disconnect the machine from the mains power supply and take steps to prevent
accidental reconnection. TURNING OFF THE ON SWITCH OR PRESSING THE STOP KEY IS NOT
ENOUGH.
 Disconnect the electrical connection of any circuit external to the machine; for example external dosing
equipment, central vending units, linen feeders or folders, etc. The electrical connection for these circuits
is independent of the machine's electrical connection.
 To prevent the risk of electrical discharge caused by residual voltage, wait at least five minutes before
removing any guard or cover from the machine.
Failure to follow these warnings may cause a serious accident.
25. CONTACT the Installation Contractors or the Authorised Technical Service (see Notes 3 and 2) in the
event of any doubt, anomaly or problem.
26. It is advisable to copy and enlarge the SAFETY INSTRUCTIONS and place them in a visible place in the
laundry.
27. THE MANUFACTURER ACCEPTS NO RESPONSIBILITY IF THESE SAFETY INSTRUCTIONS AND
ALL THE INFORMATION IN THE CORRESPONDING MANUALS ARE NOT FOLLOWED.
SAVE THIS INSTRUCTIONS.
Safety instructions
6
Cod. 598144
Rev. 11/0717