Chapter 6
Install and Upgrade Internal Modules and FRUs
Remove NIM-SSD or NIM-HDD from the Router
To remove the module from the router:
Step 1
Slip on the ESD-preventive wrist strap that was included in the accessory kit. Loosen the screw fasteners
(11) located on the SSD slots on the right of the input/output (I/O) side of the Cisco 4451-X ISR.
(Figure
Figure 6-17
2
1
Step 2
Using a Phillips screwdriver, loosen the captive screws on either side as shown in
Figure 6-18
OL-32185-02
6-17).
Remove the NIM-SSD or NIM-HDD from the Router
Captive screws holding the NIM-SSD to the
router
Remove the NIM-SSD or NIM-HDD from the Router
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Remove and Replace Cisco NIM-SSD or NIM-HDD
L
L
1
1
1
Figure
6-17.
1
6-23