C H A P T E R 4 Configure Initial Router Settings On Cisco 4000 Series Isrs - Cisco 4451 ISR Hardware Installation Manual

Perform Initial Configuration on Cisco 4000 Series ISRs
Note
If you make a mistake while using the setup command facility, you can exit and run the setup command
facility again. Press Ctrl-C, and enter the setup command in privileged EXEC mode (Router#)
To configure the initial router settings by using the setup command facility, follow these steps:
Step 1
From the Cisco IOS-XE CLI, enter the setup command in privileged EXEC mode:
Router> enable
Password: <password>
Router# setup
Continue with configuration dialog? [yes/no]:
You are now in the Setup Configuration Utility.
Depending on your router model, the installed interface modules, and the software image, the
prompts in the setup command facility vary. The following steps and the user entries (in bold) are
shown only as examples.
Note
Note
Step 2
To proceed using the setup command facility, enter yes.
Continue with configuration dialog? [yes/no]:
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 3
To enter the basic management setup, enter yes.
Would you like to enter basic management setup? [yes/no]: yes
Step 4
Enter a hostname for the router (this example uses 'myrouter'):
Configuring global parameters:
Enter host name [Router]:
Step 5
Enter an enable secret password. This password is encrypted (for more security) and cannot be seen
when viewing the configuration.
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: cisco
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
4-2
--- System Configuration Dialog ---
This setup command facility is also entered automatically if there is no configuration on the
router when it is booted into Cisco IOS-XE.
If you make a mistake while using the setup command facility, you can exit and run the setup
command facility again. Press Ctrl-C, and enter the setup command at the privileged EXEC
mode prompt (Router#). For more information on using the setup command facility,
Setup Command chapter in Cisco IOS Configuration Fundamentals Command Reference,
Release 12.2T, at the following URL:
http://www.cisco.com/en/US/docs/ios/12_2t/fun/command/reference/122tfr.html
myrouter
Chapter 4 Configure Initial Router Settings on Cisco 4000 Series ISRs
see The
OL-32185-02