Chapter 6
Install and Upgrade Internal Modules and FRUs
Install the SSD mSATA Storage Device
To install a SSD mSATA storage device:
Step 1
Read the
module.
Step 2
Remove the chassis cover. For instructions on removing the chassis cover, see
Chassis Cover" section on page
Step 3
Place the SSD mSATA storage device on the SSD mSATA connector and align the device's contact edge
with the corresponding socket in the connector.
Step 4
Press the device downward into the connector until it is level with the surface of the connector.
Step 5
While holding the device down, screw the device into place (see
Figure 6-49
OL-32185-02
"Safety Warnings" section on page 6-2
6-4.
Flash Memory Card and SSD mSATA Storage Device Locations
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Install and Remove an SSD mSATA Storage Device
and disconnect the power supply before you replace any
Figure
6-49).
1
1
2
3
4
5
6
"Remove and Replace the
6-69