Install and Remove an SSD mSATA Storage Device
1
3
5
Step 6
Replace the chassis cover. See
Remove the SSD mSATA Storage Device
To remove the SSD mSATA storage device:
Step 1
Read the
module.
Step 2
Remove the chassis cover. For instructions on removing the chassis cover, see
Chassis Cover" section on page
Step 3
Unscrew the screws that attach the SSD mSATA storage device to the chassis. See
Step 4
The card should popup once the screws are removed.
Step 5
Install a new SSD mSATA memory device if needed. See
page
Step 6
Replace the chassis cover. See
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
6-70
Supplied screw
Flash memory card
Flash memory card connector
"Safety Warnings" section on page 6-2
6-69.
Chapter 6
2
Supplied screw
4
SSD mSATA storage device
6
SSD mSATA connector
"Remove and Replace the Chassis Cover" section on page
and disconnect the power supply before you replace any
6-4.
"Remove and Replace the Chassis Cover" section on page
Install and Upgrade Internal Modules and FRUs
"Remove and Replace the
Figure
Install the SSD mSATA Storage Device,
6-4.
6-48.
6-4.
OL-32185-02