Install Dimm - Cisco 4451 ISR Hardware Installation Manual

4000 series integrated services routers
Table of Contents

Advertisement

Chapter 6
Install and Upgrade Internal Modules and FRUs
Figure 6-20
Step 5
Place the DIMM in an antistatic bag to protect it from ESD damage.
Step 6
Replace the chassis cover. See the

Install DIMM

Note
The DIMMS on the Cisco 4400 Series ISRand Cisco 4300 Series ISR are not interchangeable.
To install a DIMM:
Step 1
Read the
replace any module.
Step 2
Remove the chassis cover. For the Cisco 4451-X ISRs, see the
section on page
Step 3
Locate the DIMM module. See the
section on page 6-7
Step 4
Make sure that both latches on the DIMM connector are in the open position.
Step 5
Orient the DIMM so that the polarization notch lines up with the polarization key on the connector. See
Figure
OL-32185-02
Remove a DIMM
"Safety Warnings" section on page 6-2
6-4.
to find the DIMM sockets on the router.
6-21.
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Install and Remove DDR DIMMs on Cisco 4400 or 4300 Series ISRs
"Remove and Replace the Chassis Cover" section on page
section and disconnect the power supply before you
"Locate Internal and External Slots for Modules on Cisco 4451 ISR"
"Remove and Replace the Chassis Cover"
6-4..
6-27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4351 isr4331 isr4221 isr4431 isr4321 isr

Table of Contents