Epson MX-80 User Manual page 13

Hide thumbs Also See for MX-80:

A plastic plate fell out of the access hatch on the inside back of the lid when we

opened the case. We can either replace this plate as we replace the lid, tape it to

the OUTside of the hole, or add it to our growing collection of printer parts. The

switches can be REset through this hatch without having to reopen the case (by

psing a flashlight and small screwdriver or ball-point pen).

Got all the settings correct for your Computer? Put the case back together and

tighten the screws. The Printer cover goes back on the way it came off — very

carefully. Same with the transparent lid.

Printer Cable Connection

We're getting closer to the good stuff.

Be sure both the computer and Printer are turned O F F . Connect the cable to the

Printer only. EPSON supplies a variety of cables to match different computers. Be

sure you have the right one. Do n o t connect the other end of the cable to the

computer yet.

Take your time! Double-check to ensure that the cable is in place and locked. It

may take a firm push on the connector to get the clips secured. Without this tight

connection, printing may be erratic. Again — leave the other end disconnected.