Power-Up Sequence; Touch Screen Areas - GE PACE5000 User Manual

3 Operation
3.2

Power-up sequence

The following sequences of operation shows the instrument display.
Note: The following sequence is an example, the values and selections displayed depend on
the range(s) and options enabled in the instrument
1. Set the power supply to ON:
2. The display shows the power-up sequence.
3. The instrument carries out a self-test.
If the test finds a fault, the display shows an
error (Ref: Fault Finding and Testing, Section
5).
4. If the self-test is successful the system
enables the touch screen and changes to
measure mode.
5. The touch screen shows the measured
pressure in the parameters selected in set-up.
6. The instrument is now ready for use.
Note: The PACE 6000 shows a single display
(default) this is the left hand pressure control
module. Change to dual display in Global Set-
up/Display.
1
Measure set-up
5
Status (touch to enter control set-up
K0443 Revision A
6 5

Touch screen areas

2
Control/Measure
6
Nudge down
3 - 2
(Ref: Touch screen
1
2
3
4
3 4
Nudge up
areas).
Set-point entry
[EN] English