GE PACE5000 User Manual page 66

PACE Pressure Controller User Manual
RS232
Located on the rear panel an external RS232 connection requires the following:
Connector
Communications
Baud Rate power-up default
Baud rates selectable **
Parity
Flow control
Protocols †
New data up-date rate
Built-in EMC Filtering and Transient voltage protection
** Selectable through the user interface
IEEE 488
Located on the rear panel an external IEEE 488 connection requires: the following:
Connector
Communications
Default Address
Protocols †
New data up-date rate refer to data sheet
Built-in EMC filtering and transient voltage protection.
† Not all protocols available on all models.
Ethernet
Located on the rear panel an external Ethernet connection requires the following:
Connector
Protocol
Terminator
Default Address
Host name
Web Password
Access control
Reset LAN Settings Selected in Supervisor set-up menu
[EN] English
24-way 'D' female wired as IEEE 488 standard
IEEE 488 GPIB
16
SCPI, DPI 500, DPI 510, DPI 515, DPI 520
Ethernet RJ45
SCPI
CR/LF
Auto IP (0.0.0.0)
PACExxxxxx (where xxxxxx = serial number)
0268
Open
6 - 13
9-way 'D' female wired as per Table 2-1
RS232 point-to-point only
(DPI 520 daisy chain is not supported)
9600, no parity & handshake = xon/xoff
2400, 4800, 9600, 19k2, 38k4, 57k6 & 115k2
None, Odd & Even
None, Hardware & xon/xoff
SCPI, DPI 500, DPI 510, DPI 515, DPI 520
refer to data sheet
† Not all protocols available on all models.
K0443 Revision A