Table of Contents
Advertisement
Connecting VP-428H2
Always switch off the power to each device before connecting it to your VP-428H2. After
connecting your VP-428H2, connect its power and then switch on the power to each device.
To connect VP-428H2 as illustrated in the example in
1. Connect a DP source (for example, a laptop) to the DP IN DisplayPort connector
2. Connect an HDMI source (for example, a Blu-ray player) to the HDMI IN connector
3. Connect a computer graphics source (for example, a laptop) to the PC IN 15-pin HD
connector
4. Connect an analog stereo audio source (for example, from the laptop) to the AUDIO IN
3.5mm mini jack
5. Connect the HDBT OUT RJ-45 port
TP-580Rxr).
6. Connect an IR sensor to the IR IN 3.5mm mini jack
projector connected to the HDBT receiver that is connected to HDBT OUT
The projector IR remote control transmitter sends commands to the projector via the IR
sensor.
7. Connect the IR IN 3.5mm mini jack to an IR emitter (for example, to control the
HDMI-connected Blu-ray player via the HDBT receiver that is connected to HDBT OUT
).
8. Connect a control system to the CTRL (G, Rx, Tx) terminal block connectors
control
VP-428H2.
9. Connect a control system to the DATA (G, Rx, Tx) terminal block connectors
tunnel control commands via HDBT OUT.
10. Connect the RJ-45 Ethernet port
11. Connect the 48V power adapter
VP-428H2 - Connecting VP-428H2
.
.
Figure
to a receiver (for example, the Kramer
(for example, to control the
to tunnel Ethernet data via HDBT OUT.
and connect the adapter to the mains.
Kramer Electronics Ltd.
3:
).
to
to
.
.
7
Advertisement
Table of Contents
