Setting Up System Security; Setting The Passcode; Editing The Passcode - Hach sc100 User Manual

4.4 Setting up System Security

4.4.1 Setting the Passcode

Step Select
1
2
3
4 —
5
6

4.4.2 Editing the Passcode

Step Select
1
2
3
4
5
6
7
The passcode feature of the sc100 restricts unauthorized access to configuration and
calibration settings. The passcode is factory set to sc100 (the five digits must be followed
by a space to remove the trailing asterisk). The following two options are available:
Disabled: All configuration settings and calibrations can be changed. This is the default.
Enabled: Certain calibration and Test/Maint settings/operations cannot be accessed
without the passcode. If the passcode is enabled, it may be edited
passcode can include up to six digits (alpha and/or numeric and available characters). If
the instrument is reset using the Configure/Default Setup menu selection, the passcode
will return to the factory default. If a passcode is forgotten, obtain the Master passcode
from the Technical Consulting Services Department, see
Main Menu or Main Measurement Screen
EDIT PASSCODE select character (shown in brackets)
EDIT PASSCODE move to the next character
Main Menu or Main Measurement Screen
Menu Level/Instructions
MAIN MENU
SYSTEM SETUP
SECURITY SETUP
SET PASSCODE
Highlight ENABLE
Menu Level/Instructions
MAIN MENU
SYSTEM SETUP
Highlight SECURITY SETUP
ENTER PASSCODE
EDIT PASSCODE
Operation
(section 4.4.2). The
Section 9 on page 45.
Confirm
Confirm
—
—
—
—
—
33