Hach sc100 User Manual page 14

Installation
Figure 9 Panel Mounting the Controller
1. Controller
2. Gasket, Neoprene, panel mount,
Cat. No. 1000A4F3249-101
3. Panel (maximum thickness is 9.5 mm (
4. Mounting Foot (2), Cat. No. 1000B4F3222
5. Mounting bracket, controller, Cat. No. 1000C4F3217-101 11. It may be necessary to remove the sensor connectors.
6. Pan head screw (4), Cat. No. 5867400
14
1
11
3
/ inch))
8
To remove the sensor connectors before inserting the controller enclosure into the panel
cut-out:
1. Disconnect the wires at terminal block J5, see
2. Loosen and remove the nut securing the sensor connector inside the enclosure.
Remove the sensor connector and wires. Repeat step 1 and 2 for the other sensor
connector.
3. After the controller is in place in the panel, reinstall the sensor connectors and
reconnect the wiring to terminal J5 as shown in
2
8
9
8
10
7. Lock washer, ¼-inch I.D., (4) Cat. No. 8H1336
8. Hex nut (4), Cat. No. 5867300
9. Flat washer (4), Cat. No. 8H1346
10. Pan head screw, M6 x 1.0 x 150 mm (4),
Cat. No. 5867600
see procedure below.
Figure 19 on page
3
4
5
24.
Figure 19 on page 24.
6 7