Hach sc100 User Manual page 39

4.9 System Setup Menu (continued)
NETWORK SETUP (this menu appears only if a network card is installed in the controller)
SET MODE
Auto or Manual
MODBUS ADDRESS
Highlight sc100 Analyzer, or either connected sensor then press
address (each source must have a different address) then press
BAUD RATE
Select a baud rate of 9600, 19200, 38.4K, 57.6K, or 115.2K. Default: 19200
STOP BITS
Select 1 or 2 stop bits. Default: 1
MODBUS MODE
Select RTU or ASCI. Default: RTU
DATA ORDER
Select Normal or Swapped. Default: Swapped
DISPLAY SETUP
ADJUST CONTRAST
Use the and
UP DOWN
LANGUAGE
The default is English. Choose Spanish, German, or French to allow all menus to appear in the selected language.
SET DATE/TIME
Select the date format and to set the date and time (24-hour (military) format), see
SECURITY SETUP (Enter a 6-digit passcode)
SET PASSCODE
DIISABLE
Disables system security. See
ENABLE
Enables system security. See
LOG SETUP
DATALOG SETUP
Setup datalogging of displayed sensor measurements
CALCULATION
SET VARIABLE X
Select the sensor corresponding to the variable set as "X".
SET VARIABLE Y
Select the sensor corresponding to the variable set as "Y".
SET PARAMETER
Select the parameter to be associated with the variable.
SET FORMULA
Select the formula of the calculation to be performed on "X" and "Y".
keys to increase or decrease the contrast, see
section 4.4 on page
section 4.4 on page
. Choose a number between 1 and 247 as the
ENTER
.
ENTER
section 4.3.1 on page
33.
33.
Operation
31.
section 4.3.3 on page 32.
39