Table of Contents
Advertisement
B.1 Initializing the SIP-GW4 Card
B.1 Initializing the SIP-GW4 Card
If you have forgotten, for example, the IP address or log-in password you set for the SIP-GW4 card, follow the
procedure below to return the settings of the card to the factory default.
Note
Resetting the card will restore all settings, not just the IP address and log-in password, to the factory default.
1.
Slide the Initialize Switch on the card to the "INI" position, and then turn on the power to the PBX.
2.
To start the SIP-GW4 Maintenance Utility, log in with the default IP address, user ID, and password from
the PC connected to the card (refer to "3.2.2 Starting the SIP-GW4 Maintenance Utility").
3.
Open "2.3 Initialization" from the menu and execute initialization (refer to "3.6.3 Initialization").
4.
After initialization is complete, return the Initialize Switch to the "OFF" position.
Note
Ensure that the Initialize Switch is returned to the "OFF" position after initialization is complete.
82
Installation Manual
DIP-SW
Document Version 2008-10
Advertisement
Table of Contents
