Table of Contents
Advertisement
3.1.1 Procedure Overview
3.1 Procedure Overview
3.1.1 Procedure Overview
Installing the SIP-GW4 Card
The following steps describe the start-up procedures when installing the SIP-GW4 card in the PBX for the first
time.
1.
Install the SIP-GW4 card in the PBX.
® "2.1.2 Installing the SIP-GW4 Card in the PBX"
Note
Make sure that you have subscribed to the following for Internet connection:
•
Internet Service Provider (ISP)
•
Internet Telephony Service Provider (ITSP)
2.
Prepare the PC.
® "3.2.1 Preparing the PC"
3.
Connect cables to the card.
® "2.2.1 LAN Port Connection"
® "2.2.2 WAN Port Connection"
4.
Set up the Internet connection.
® "3.3.1 WAN Interface"
5.
Set up the ITSP connection.
® "3.4.1 Channel & SIP Telephony"
6.
Specify other settings (if necessary).
7.
Program the PBX.
® "4.1 Programming the PBX"
8.
Back up the configuration file of the SIP-GW4 card.
® "3.6.1 Backup (Download from SIP-GW4)"
Note
After you have confirmed that the card has been successfully programmed, make sure to download
the configuration file from the card and save it on your PC for backup and archive purposes.
22
Installation Manual
Document Version 2008-10
Advertisement
Table of Contents
