Table of Contents
Advertisement
3.5.2 Static Route
1.
Click 1.3.2 Static Route in the operation menu.
•
Current Active Route List: Current active routing lists are displayed. "link#1" indicates the LAN port
of the card, and "link#2" indicates the WAN port of the card.
•
Route Configuration Table: Available routing lists are displayed. If there is a route displayed in the
table, clicking the Delete button will delete the route from both Current Active Route List and Route
Configuration Table.
•
Add a Route: Additional routes can be specified.
2.
Assign each parameter referring to the descriptions below.
Parameter & Description
Destination IP Address
Specifies the destination IP address.
Destination Subnet Mask
Specifies the destination subnet mask address.
Next Hop
Specifies a gateway by selecting either an IP
address or Interface.
3.
Click Add.
A confirmation screen is displayed.
The new route specified in Add a Route is added to Route Configuration Table. If the network is
connected, the route is also added to Current Active Route List. If not, the route will be queued and added
when the network is connected.
Document Version 2008-10
Default
No default
Available IP addresses (default
route: 0.0.0.0)
24 (255.255.255.0)
0, 8–32
No default
Available IP addresses,
PPPoE
3.5.2 Static Route
Value Range
Installation Manual
53
Advertisement
Table of Contents
