Table of Contents
Advertisement
3.5.5 Bandwidth
3.5.5 Bandwidth
1.
Click 1.3.5 Bandwidth in the operation menu.
Specify the maximum amount of bandwidth for VoIP (voice, data) communication on the network. If it
requires more bandwidth than is set here, packets will not be sent. In that case, voice packets (RTP
packets) are prioritized and data to be sent via the LAN will be discarded. The bandwidth restriction set
here does not influence IP packets that are received at the interface. Set the actual amount of bandwidth
(refer to "A.1.2 Bandwidth Requirements").
2.
Assign each parameter referring to the descriptions below.
Parameter & Description
WAN (Fixed IP Address/DHCP Client)
Specifies the bandwidth for the WAN port.
Applies to connection by a fixed IP address or
DHCP Client.
*1
PPPoE
Specifies the bandwidth for PPPoE.
Applies to connection by PPPoE.
*1
When Fixed IP Address or DHCP Client is selected as the connection method in WAN Interface.
*2
When PPPoE is selected as the connection method in WAN Interface.
3.
Click Set.
A confirmation screen is displayed.
4.
The new settings must be followed by a reboot to become effective.
Do one of the following:
–
Click Reboot Now to make the changes effective now.
–
Click Reboot Later to return to the previous screen.
Note
After reboot, the card will be disconnected from the network for a number of seconds.
62
Installation Manual
Default
800
800
*2
Value Range
20–30000
20–30000
Document Version 2008-10
Advertisement
Table of Contents
