2.2 Cable Connection
Use a Category 5 (CAT 5) Ethernet cable (10BASE-T/100BASE-TX) with an RJ45 connector to connect the
SIP-GW4 card to a network device.
Note
Use only CAT 5 Ethernet cable for connection.
2.2.1 LAN Port Connection
Connect the card to your PC or to a switching hub, following the steps below, and then specify an IP address.
Note
The IP address of the SIP-GW4 card must be specified before connecting to the network. For details about
the IP address setting, refer to "3.2.1 Preparing the PC".
Connecting to a PC
When connecting the card to a PC, use an Ethernet cross cable.
1.
Connect the Ethernet cable to the LAN port of the card.
2.
Connect the other end of the cable to the PC.
Document Version 2008-10
LAN Port
Ethernet Cross Cable
2.2.1 LAN Port Connection
PC
Installation Manual
17