Interfaces - Agilent Technologies 1100 Series Service Manual

5 Introduction to the Nano Pump

Interfaces

The Agilent 1100 Series modules provide the following interfaces:
Table 50 Agilent 1100 Series Interfaces
Interface Type Pumps
CAN Yes
GPIB Yes
RS-232C Yes
Remote Yes
Analog Yes
Interface board Yes
* The well-plate sampler can be controlled through CAN via a detector that is connected via GPIB to a ChemStation.
† The vacuum degasser will have a special connector for specific use. For details see description of main board.
• CAN connectors as interface to other Agilent 1100 Series modules,
• GPIB connector as interface to the Agilent ChemStation,
• RS-232C as interface to a computer,
• REMOTE connector as interface to other Agilent products,
• Analog Output connector(s) for signal output, and
• Interface slot for specific interfacing (external contacts, BCD, LAN and so
For identification and location of the connectors Figure 5 on page 13.
Never use cables other than the ones supplied by Agilent Technologies to ensure
WA RN ING
proper functionality and compliance with safety or EMC regulations.
218
Autosampler Well-plate
Sampler
Yes Yes
*
Yes No
Yes Yes
Yes Yes
No No
Yes Yes
on).
DA Detector VW Detector
MW RI Detector
Detector
FL Detector
Yes Yes
Yes Yes
Yes Yes
Yes Yes
2 × 1 ×
Yes Yes
1100 Series Nano Pump Service Manual
Thermostatted Vacuum
Column Degasse
Compartment r
Yes No
Yes No
Yes No
Yes Yes
†
No Yes
No No