Agilent Technologies 1100 Series Service Manual page 246

6 Control Module Screens for the Nano Pump
Setup View In the Setup view, modules can be added or removed to the analysis view.
Select a module, you want to move, with the help of the selection keys. Use
function keys F7/F8 (Remove/Add) to move the highlighted module. Changes
must be activated with Done (F6).
Here, e.g. the autosampler and the thermostatted column compartment
parameters are shown on the display as well. The number of parameters for
each module is reduced as additional modules are added to the display. A
maximum of 4 modules can be shown simultaneously (If more modules are
connected to the system, you can choose up to 4 of them in Setup view).
On/Off
From the Analysis screen use the F7-key (On/Off) to proceed to the turn on
screen. Press F8 (On) once to turn on the pump. If more than one module is
available, select F8 (Pump) or turn on the entire system by selecting the System
On button and pressing Enter.
234 1100 Series Nano Pump Service Manual