Basics; Reading Barcodes; Figure 11 - Kdc Display; Figure 12 - Scanning Barcodes Using Ktsync - KoamTac KDC20 User Manual

K K DC User KDC
YOUR

3.2 Basics

Reading Barcodes

To read a barcode using the KDC, simply point the KDC at a barcode and press the scan button. Be
sure to point the scan engine window at the barcode, not at the user's face, and make sure to
position the light beam on the barcode.
If a barcode has been successfully scanned, the user will hear one short beep and the LEDs will
illuminate green. The scanned barcode data will be displayed on the KDC screen, along with the scan
time and battery level. Depending on the configuration of the KDC, other information may also be
displayed.

Figure 11 - KDC Display

Figure 12 - Scanning barcodes using KTSync

If scanning was unsuccessful, the user will hear two short beeps, the LEDs will illuminate red, and the
message Failed reading will display. If this is the case, the user should point the KDC at the barcode
and press the scan button while trying the following suggestions: