KoamTac KDC20 User Manual page 83

K K DC User KDC
YOUR
z Power On Beep: Enables or disables beep sound when KDC power is on.
z
Beep On Connect: Enables or disables beep sound when KDC is connected to the host.
z Beep On Scan: Enables or disables beep sound when KDC is scanning.
z
Beep On MS Card (KDC500 only) : Enables or disables beep sound when KDC reads a MS
Card.
z
Beep On IC Card (KDC500 only) : Enables or disables beep sound when KDC reads an EMV
Contact Card.
z Beep On NFC Card (KDC500 only) : Enables or disables beep sound when KDC reads an NFC
Tag or EMV Contactless Card.
Beep Volume
This option enables the user to adjust the beep volume from High to Low.
MFi Mode (KDC20i/30i/200i/250i/270i/300i/350i/400i)
This option Enables user to enable or disable MFi mode. MFi mode supports SPP and MFi Bluetooth
profiles. Non-MFi mode supports SPP, SPP2.0, HID iOS and HID normal.
Vibrator(KDC20/30/270/350)
Enables, disables and configure KDC vibrator.
x
There are two additional options for KDC vibrator configuration.
o Scan Success Î Specify the number of vibration when scan successfully.
o Scan Failure Î Specify the number of vibration when scan failed.
Auto Exit
This option enables KDC to automatically exit KDC Menus.
Port Status
This option enables users to enable or disable KDC port messages.
Display Format
There are various selections of display format; Time & Battery, Type & Time, Type & Battery,
Memory Status, Barcode only and Graphics.
The Graphics option enables to display 'O' for scan success and 'X' for scan failure.
Menu Barcode
This option enables users to enable or disable Honeywell special barcodes (KDC300/350C/500C
only).
Scrolling
This option enables users to enable or disable display scrolling for a barcode with more than 40
characters.(KDC500 doesn't support)
Brightness
This option enables users to adjust brightness of display.