Table of Contents
Advertisement
Service manual
SMPS replacement
1.
Remove the four Pz screws (1) that fasten the fan
guard grill to the fan, if available.
2.
Remove the fan.
3.
Remove the four TX10 screws (2) and unplug the
three main wires (3).
4.
Cut the cable tie (4) that holds the wires.
5.
Remove the DC connector (5) from the SMPS.
6.
Replace the SMPS.
7.
To install the new SMPS, follow the procedure in
reverse order.
8.
Before you close the fixture, follow the instructions
in "Closing the fixture" on page 15.
Exterior Inground 400 LED - Revision B, 08-18-2017
Figure 21: Removing the fan
4
3
Figure 22: Removing the SMPS
5
Figure 23: SMPS DC connector
1
1
2
2
13 of 18
Advertisement
Table of Contents
