Martin Exterior Inground 400 Service Manual page 8

Service manual
3. Remove the diffuser with holder, if included in the
configuration. See figure 16.
4. Remove the four TX10 screws (3) to remove the
glare shield, if included in the configuration.
5. Insert the lifting tool in the holes and lift out the
insert module.
NOTE! You can buy the lifting tool on
.
my.martin.com
6. Before you can remove the insert module from the
housing, disconnect the two green connectors (4).
The connectors connect the mains power and
DMX.
7. Before you close the fixture, follow the instructions
in "Closing the fixture" on page 15.
Exterior Inground 400 LED - Revision B, 08-18-2017
3
Figure 12: Removing the glare shield
Figure 13: Lifting the fixture insert module
4
Figure 14: Disconnecting connectors
3
4
8 of 18