Table of Contents
Advertisement
Service manual
Repair and replacement
Replacing the front glass
1.
Remove the eight Torx20 screws (1).
2.
Replace the front glass.
3.
Follow the procedure in reverse order.
NOTE! Make sure that the Atomic mark is pointing
towards the Atomic label.
Replacing the back light reflector
assembly
1.
Remove the front glass. See "Replacing the front
glass" on page 7.
2.
Remove the two Torx20 screws (1) on each side.
Atomic 3000 LED - Revision A, 11-30-2017
1
Figure 6: Replacing the front glass
Figure 7: Position of the front glass
1
Figure 8: Removing the screws
1
1
7 of 20
Advertisement
Table of Contents
