Powerup Led Patterns - GE IC695PNC001 User Manual

Powerup LED Patterns

At powerup, the LEDs show the blink patterns described below. The LEDs also blink diagnostic
patterns for certain operating errors and for module identification. See "Chapter 5, Diagnostics" for a
description of the special blink patterns.
Step LED/ Blink pattern
1 All LEDs off
2 STATUS LED solid Green
OK LED blinks Amber with
special blink code
OK, LAN, and STATUS
LEDs blink green in unison
(0.5 second ON/ 0.5
second OFF)
3 LAN and STATUS LED
solid Green
4 LAN LED solid Green
LAN and STATUS LED
blink Green (0.5 second
ON and 0.5 second OFF)
5 OK LED solid Green
OK LED blinks Green (0.5
second ON and 0.5 second
OFF)
Note: Under certain ambient operating temperatures, the PROFINET Controller may momentarily
display the overtemperature pattern during power up, while it is calibrating its thermal protection
functions. This indication may be ignored, and no overtemperature entry is added to the Local Log
table, the Controller Fault table or I/O Fault table.
For details, see "Special LED Blink Patterns" in chapter 5.
GFK-2571A
Description
Normal operation
Normal operation
Fatal Initialization or Diagnostics
Failure, H/W Module Identity
Information not available
Invalid firmware detected. Module is
waiting for firmware update. Blink
pattern continues during firmware
update.
Normal operation
Normal operation
Update of module firmware. After the
automatic update completes, the LEDs
blink Amber and the module resets,
which restarts the powerup process.
Normal operation. Powerup completed
and backplane communications
established.
Module powerup completed, but
communication not yet established
over the RX3i backplane.
Chapter 2 Installation
1 OK
2 LAN
3 STATUS
4 CONFIG
PNC001
TO INSTALL, TORQUE TO
6 IN-LB. TO UNINSTALL,
REVERSE MOTION
ACTIVE
USB
RESTART
!
IP ADDRESS
INTERFACE MAC
PORTS
FRONT
3 4
1 2
2-9
2