GE IC695PNC001 User Manual page 124

7
PROFINET MRP Port Status TLV
The PROFINET MRP Port Status indicates the current MRP status of the network port over which
this LLDP message is sent.
This TLV is required when the LLDP sender is an MRP port. It is not present in the LLDP packet
issued from a non-MRP port.
The PNC supports the following values:
Subfield
MRP Domain ID
MRRT Port Status
PROFINET Chassis MAC TLV
The PROFINET Chassis MAC indicates the internal MAC address used by the PROFINET stack.
This is not the MAC address of any individual network port.
MAC/PHY Config/Status TLV
The MAC/PHY Configuration/Status indicates the supported auto-negotiation capability, the current
negotiated capability, and the MAU type of the network port over which this LLDP message is sent.
Field
Auto- Bit 0: Autonegotation supported (1= Yes, 0 = No)
negotiation Bit 1: Autonegotiation status (1 = Enabled, 0 =
Support/Status Disabled)
Bits 2-7: Reserved
Auto- Note: There are no AutoNegCapability definitions
negotiation for 100Base FX or LX (HD or FD). A device that
supports these must advertise "Other".
Advertised
Capability
Operational Typical values are:
MAU Type 0x000B: 10BaseT FD
0x0010: 100BaseTX FD
0x0012: 100Base FX FD (Multi-mode fiber)
0x0018: 1000BaseLX FD (Long wavelength fiber)
0x001A: 1000BaseSX FD (Short wavelength fiber)
0x001E: 1000BaseT FD (Copper)
PACSystems* RX3i PROFINET Controller Manual – December 2011
7-8
Contains the MRP domain UUID. Assigned internally by the network node.
Set to 0xFFFFFFFF-FFFF-FFFF-FFFF- FFFFFFFFFFFF.
0x00 = Off / Not Used
Values
Value
RX3i PROFINET Controller
0x03 (Autonegotiation supported
and enabled)
Copper Ports:
0x6C03 = 10/100/1000T HD+FD
SFP Ports:
(Depends on SFP type)
0x000C = 1000 LX/SX HD+FD
0x6C03 = 10/100/1000T HD+FD
0x8000 = Other (100 FX, LX)
SC Fiber Ports:
0x8000 = Other (100 FX)
Copper Ports:
0x001E = 1000T FD
SFP Ports:
(Depends on SFP type)
0x0012 = 100 FX, LX
0x0018 = 1000 LX FD
0x001A = 1000 SX FD
0x001E = 1000 T FD
SC Fiber Ports:
0x0012 = 100 FX FD
GFK-2571A