GE IC695PNC001 User Manual page 34

2
Detailed LED Descriptions
OK LED
The OK LED indicates whether the module is able to perform normal operation.
Green, ON
Green, blink pattern
Amber, blink pattern
OFF
LAN LED
The LAN LED indicates access to and activity on the Ethernet network. The LAN LED indicates
network packets are being processed by the network interface (not just passing through the
embedded switch).
Blinking ON
Blink pattern
OFF
STATUS LED
The STATUS LED indicates the condition of the PROFINET Controller during normal operation. It
indicates whether an entry other than the startup event is present in the module's local log. STATUS
can also indicate whether any of the MAC addresses are invalid.
The STATUS LED state is reset when the local log is cleared. For more information see the
Command Line Interface clear log command.
Green, ON
OFF
Green, blink pattern
Red, blinking
CONFIG LED
The CONFIG LED indicates whether the module has received its configuration from the RX3i CPU.
Green, ON
OFF
Green, blink pattern
PACSystems* RX3i PROFINET Controller Manual – December 2011
2-10
OK
Fatal error. Flashes once between error codes blinked on the OK
LED
Fatal error
Not OK
The module's network interface is active
Fatal error. Flashes once between error codes blinked on the OK
LED
No activity
No new local log table entries
New local log table entry
Fatal error. Flashes once between error codes blinked on the OK
LED. Chapter 5 provides more detailed information about this
LED's additional behavior during fatal error conditions.
Invalid MAC address (all MAC addresses are validated; error
indicates if any address is bad)
Configured
Not configured
Fatal error. Flashes once between error codes blinked on the OK
LED
GFK-2571A