Techkon SpectroDrive Manual page 25

Certain settings are done only once, after the software is installed or have to be
changed only occasionally when fundamental parameters have altered. For example
the menu language, the selection of the measurement device or the definition of a
new printing press will be set once and do not have to be set for each and every
print job to be carried out later.
This kind of settings is made by pushing one of the yellow "Settings" buttons (1.,
p. 24) and then selecting one button from the sublayer (2., p. 24). The referring win-
dow opens (3., p. 24) and can be edited.
All settings which were made, can later be recalled when defining a "Print job",
where the screen will appear in blue color.
When you start ExPresso, the sublayers "Make ready", "Measure" and "Analyze" in
the section "Print job" are shaded an can not be activated until you have set up all
necessary informations concerning your printing- and measurement-conditions in the
"Settings". Finally you have to click on the "Select" button in the "Print job" section
to define or select a print job. Now all menu items in the "Print job" section can be
used.
Manual TECHKON SpectroDrive Chapter 3 – How to use SpectroDrive Page 25