Techkon SpectroDrive Manual page 18

How to change the lamp
1.
2.
3.
Page 18 Manual TECHKON SpectroDrive Chapter 3 – How to use SpectroDrive
1. Open the SpectroDrive device.
A TORX™ T10 screwdriver was shipped
with the SpectroDrive unit. Use it to unscrew
the four screws as shown in the picture.
2. Disconnect the battery from the main-
board. To prevent damages to the battery
make sure only to pull the plug, not the cable.
3. Disconnect the lamp as shown in the
picture. Be sure to disconnect the black cable
only.