Basic Programming - Danfoss VLT Decentral Drive FCD 302 Operating Manual

Commissioning
Indicator
15 On
16 Warn
5 5
17 Alarm
Table 5.4 Legend to Illustration 5.1, Indicator Lights (LEDs)
D. Operation keys and reset
Operation keys are at the bottom of the LCP.
Key
18 [Hand On]
19 Off
20 [Auto On]
21 Reset
Table 5.5 Legend to Illustration 5.1, Operation Keys and Reset
NOTICE
To adjust the display contrast, press [Status] and the
▲ ▼
[ ]/[ ] keys.

5.3 Basic Programming

Frequency converters require basic operational
programming before running for best performance. Basic
operational programming requires entering motor
nameplate data for the motor being operated and the
minimum and maximum motor speeds. Enter the data in
accordance with the following procedure. See
chapter 5.2 Local Control Panel Operation, for detailed
instructions on entering data through the LCP. Enter the
data with power ON, but before operating the frequency
converter.
1. Press [Quick Menu] on the LCP.
2. Use the navigation keys to scroll to parameter
group Q2 Quick Setup and press [OK].
28
VLT
Color Function
Green The ON indicator light activates
when the frequency converter
receives power from the mains
voltage, a DC bus terminal, or a
24 V external supply.
Yellow When warning conditions are met,
the yellow WARN indicator light
comes on and text appears in the
display area identifying the
problem.
Red A fault condition causes the red
alarm LED to flash and an alarm
text is shown.
Function
Starts the frequency converter in local
control.
•
An external stop signal by control input
or serial communication overrides the
local hand on.
Stops the motor but does not remove power
to the frequency converter.
Puts the system in remote operational mode.
•
Responds to an external start command
by control terminals or serial communi-
cation.
Resets the frequency converter manually
after a fault has been cleared.
Danfoss A/S © 11/2016 All rights reserved.
®
Decentral Drive FCD 302
13.7%
Quick Menus
Q1 My Personal Menu
Q2 Quick Setup
Q3 Function Setups
Q5 Changes Made
Illustration 5.2 Parameter Group Q2 Quick Setup
3. Select language and press [OK].
4. Then enter the motor data in
parameter 1-20 Motor Power [kW]/
parameter 1-21 Motor Power [HP] through
parameter 1-25 Motor Nominal Speed. The
information can be found on the motor
nameplate. The entire quick menu is shown in
International/North American Default Parameter
Settings
0.0 Hz
Motor Setup
1 - 21 Motor Power [kW]
2.2 kW
Illustration 5.3 Motor Set-up
5. Continue the set-up of Quick Menu parameters:
0.75A
4a Parameter 1-20 Motor Power [kW]
4b Parameter 1-21 Motor Power [HP]
4c Parameter 1-22 Motor Voltage
4d Parameter 1-23 Motor Frequency
4e Parameter 1-24 Motor Current
4f Parameter 1-25 Motor Nominal Speed
0.00kW
5a Parameter 5-12 Terminal 27 Digital Input.
If terminal default is Coast inverse, it is
possible to change this setting to No
function.
5b Parameter 1-29 Automatic Motor
Adaptation (AMA). Set the desired AMA
1 (1)
1(1)
Q2
MG04F502