Table of Contents
Advertisement
Error in communications execution (200 to 299)
Code Message
221
Setting conflict
222
Data out of range
223
Too much data
224
Illegal parameter value
241
Hardware missing
260
Expression error
270
Macro error
272
Macro execution error
273
Illegal macro label
275
Macro definition too long
276
Macro recursion error
277
Macro redefinition not allowed
278
Macro header not found
Error in communications Query (400 to 499)
Code Message
410
Query INTERRUPTED
420
Query UNTERMINATED
430
Query DEADLOCKED
440
Query UNTERMINATED after
indefinite response
Error in System Operation (912 to 914)
Code Message
912
Fatal error in Communications-
driver
Warning
Code Message
5
*OPC/? exists in message
Other errors (350 and 390)
Code Message
350
Queue overflow
390
Overrun error
(only Serial(RS-232))
IM 253710-11E
Action
Check the relevant setting.
Check the setting range.
Check the data byte length.
Check the setting range.
Check availability of options.
Equation is not allowed.
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Action
Check transmission/reception order.
Check transmission/reception order.
Limit the length of the program message including
<PMT> to 1024 bytes or less.
Do not enter any query after
Action
Servicing is required.
Action
Place the
or
*OPC
Action
Read the error queue. Code 350 occurs when the error queue
is full up. This message is output only for the
query and is not displayed on the screen.
Execute with a lower baud rate.
Note
Code 350 indicates overflow of error queue. This code is returned as a response to the
"
STATus:ERRor?
" query; it does not appear on the screen.
*IDN?
and
*OPT?
.
at the end of the program message.
*OPC?
STATus:ERRor?
Appendix 2 Error Messages
Reference Page
Chapter 4
Chapter 4
Chapter 4
Chapter 4
—
—
Reference Page
3-2
3-2
3-2
—
Reference Page
—
Reference Page
—
Reference Page
5-5
—
App-3
App
Advertisement
Table of Contents
