Toshiba B-EX4T1-G/T Operation Manual page 95

TPCL font
Item
Font type
Font Code
BMP Width
correction factor
BMP Cap height
correction factor
BMP Descender
correction factor
Outline Cap height
correction factor
Outline Descender
correction factor
Outline Width
correction factor
Outline height
correction factor
BMP
Inter-character
space
Outline
inter-character
Selects a TEC font type from the following 4 types:
B: Bitmap
O: Outline
G: Writable character
T: TrueType
Specifies a TEC font which the Zebra font is converted into.
Note: Set a proper value according to the External Equipment Interface
Specification (TPCL command manual).
Sets the minimum width of the selected TEC bitmap and writable character in
units of dots.
Basically, the width of the original sized font (no magnification) should be
specified.
Note: Be sure to set "0" for the outline/TTF.
Sets the minimum cap height of the selected TEC bitmap and writable
character in units of dots. (*1)
Basically, the cap height of the original sized font (no magnification) should be
specified.
Note: Be sure to set "0" for the outline/TTF.
Sets the minimum descender size of the selected TEC bitmap and writable
character in units of dots. (*2)
Basically, the descender size of the original sized font (no magnification)
should be specified.
Note: Be sure to set "0" for the outline/TTF.
Sets the ratio of the cap height to the height of the selected TEC outline and
TrueType font in units of percentage. (1 = 0.1%)
Note 1: The sum of this value and that of the descender correction factor
below must be 1000.
Note 2: Be sure to set "0" for the bitmap/writable character.
Sets the ratio of the descender size to the height of the selected TEC outline
and TrueType font in units of percentage. (1 = 0.1%)
Note 1: The sum of this value and that of the cap height correction factor
above must be 1000.
Note 2: Be sure to set "0" for the bitmap/writable character.
Sets the width correction factor for the selected TEC outline and TrueType font
in units of percentage. (1 = 1%, Range: 50 to 300, 100% = No correction)
Note: Be sure to set "0" for the bitmap/writable character.
Sets the height correction factor for the selected TEC outline and TrueType
font in units of percentage. (1 = 1%, Range: 50 to 300, 100% = No correction)
Note: Be sure to set "0" for the bitmap/writable character.
Sets the inter-character space correction factor for the selected TEC bitmap
and writable characters in units of dots. (0 dot = No correction)
Note: Be sure to set "0" for the outline/TTF.
Sets the ratio of the inter-character space correction factor to the character
width of the selected TEC outline and TrueType font in units of percentage. (1
Description