Toshiba B-EX4T1-G/T Operation Manual page 41

[Drive Voltage 2 (Feed)]: (Other than B-EX4D2-G/T (203dpi/300dpi) / B-EX4T1-T JP (305dpi) /
B-EX4T3-H (600dpi))
Sets fine adjustment of the ribbon feed motor voltage (torque).
This setting is used when Ribbon Width is TYPE2.
The fine adjustment value set by the Ribbon Motor Drive Voltage Fine Adjust command [RM] is
displayed in the left box.
When the parameter is not retrieved, the value in the left box becomes zero (0).
Default
Range
[RTC] Group
[Date Time]:
The current date and time programmed for the RTC module are displayed.
This setting cannot be changed.
[Battery Check]:
Selects whether to enable or disable the battery check function.
Default
Options
[Renewal]:
Selects the timing when the date and time are updated during printing.
Default
Options
[Password] Group
[System Mode Password]:
Selects whether or not the password used for entering the SYSTEM mode is enabled.
To set this field, the old password is required.
When you enter an incorrect old password, you cannot change the password.
[New Password]:
Sets a password to be used for entering the SYSTEM mode.
To set the password, the old password is required.
When you enter an incorrect old password, you cannot change the password.
This field is effective only when the SYSTEM mode password is enabled.
Enter four characters from "0" to "F".
Entries are not case-sensitive.
Since passwords are security information, they are displayed with hidden characters except when
they are being entered.
Default
Range
[Old Password]:
Enters the password currently set on the printer.
This password is set to cancel a password for entering the SYSTEM mode.
Enter four characters from "0" to "F".
Entries are not case-sensitive.
Since passwords are security information, they are displayed with hidden characters except when
they are being entered.
To enable the new password, enter "0000".
Default
Range
0
-15 to +10
Disable
Disable, Enable
Batch
Batch, Page
0000
0000 to FFFF
0000
0000 to FFFF