Toshiba B-EX4T1-G/T Operation Manual page 94

[Get printer param.]
Retrieves the settings from the printer. (Settings of all pages will be retrieved.)
Note: If no Initial Values & Table files have been sent to the printer before, no data cannot be obtained
from the printer.
[Reset to default]
Restores all settings to the default.
<Font Conversion Table set items>
Z font
Item
Z Font Code
Z Font Name
Z Font Kind
Minimum width
Minimum height
Font code for Zebra font (0 to 9, A to Z) is displayed.
Specifies a file name of the Zebra font.
Note: Storage location of the file must be specified, like "Z:A.FNT".
Z:ROM,R:RAM,B:FLASH CARD,E:COMPACT FLASH,A:ON BOARD FLASH
Selects a Zebra font type from the following three:
S: Scalable (0 font)
M: Bitmap Monospace (A to H font)
P: Bitmap Proportional (P to V)
Note: Set a proper value according to the ZPL II Specification.
Sets the minimum width of the selected font in units of dots.
Note 1: Set a proper value according to the ZPL II Specification.
Note 2: Be sure to set "0" for the scalable font.
Set the minimum height of the selected font in units of dots.
Note 1: Set a proper value according to the ZPL II Specification.
Note 2: Be sure to set "0" for the scalable font.
Description