Located at the back of these refrigerators, the basic function of Clean Back is to esthetically improve the
back of the product.
Should there be a need to replace it or access the condenser, see the procedure in item 6.10 – Replacing
or Removing the Clean Back.
5.13 – Can Rack
Located in the Refrigerator Door, the Can Rack, is a support
to store cans easily, it was developmented for stores up six
cans simultaneously.
Note: The Can Rack, is not available for the
5.14 – Capacitor
This is a march capacitor with a capacity of 5 µF , its function is help the compressor works efficient and not
to execute startup
To replace it remove the metallic Cover of the power module to access its fastening nut.
6 – COMPONENT ASSEMBLING, DISASSEMBLING AND REPLACEMENT:
In order for some functional components to be replaced it is necessary to disassemble the Evaporator
covers. Then, see the procedures to disassemble them and to replace components:
6.1 – Disassembling the Evaporator Front and Rear Covers:
MSEX0025_rev01
Important
Never block the Clean Back upper air circulation vents, as it will affect the
performance of the product.
WRM34, WBM35 models.
Capacitor
21