Download Print this page

Adjustable Half-Width Freezer Shelf; Pull-Out Freezer Floor; Door Features; Door Rails - Whirlpool ST21PKXJW00 Use & Care Manual

Whirlpool top-mount refrigerator use & care guide
Hide thumbs

Advertisement

Adjustable Half-width
Freezer Shelf
(on some models)
To remove and replace the shelf:
1. Remove the shelf by lifting the shelf up and pulling straight
out.
2. Replace the shelf over the supports and lower it into place.

Pull-out Freezer Floor

(on some models)
To remove and replace the freezer floor:
1. Lift both back "fences" up and out.
2. Remove the freezer floor by pulling it out about 1 in (25.40
mm) with one hand around the air tower section (center back)
and one hand at center front.
3. Lift up floor at rear until hooks release from cabinet and pull
the floor out the rest of the way.
4. Replace the freezer floor by sliding the floor straight in until
the hooks drop into place at rear of cabinet.
5. Replace "fences" by aligning pins with socket in the floor, and
pushing down until they snap into place.

DOOR FEATURES

Your model may have some or all of these features. Features that
can be purchased separately as product accessories are labeled
with the word "Accessory." Not all accessories will fit all models.
If you are interested in purchasing one of the accessories, please
call the toll-free number on the cover or in the "Assistance or
Service" section.

Door Rails

The door rails may be removed for easier cleaning.
Snap-on Door Rails
To remove and replace the rails:
1. Remove the rails by pushing in slightly on the front of the
bracket while pulling out on the inside tab. Repeat these
steps for the other end of the rail.
2. Replace the rails by aligning the ends of the brackets with the
buttons on the sides of the door liner. Firmly snap bracket
and rail assembly onto the tabs above the shelf as shown.
Drop-in Door Rails
To remove and replace the rails:
1. Remove the rails by pulling straight up on each end of the rail.
2. Replace the rails by sliding the shelf rail into the slots on the
door and pushing the rail straight down until it stops.

Door Bins

(on some models)
To remove and replace the bins:
1. Remove the bin by lifting it up and pulling it straight out.
2. Replace the bin by sliding it in above the desired support and
pushing it down until it stops.

Can Rack

(on some models - Accessory)
To remove and replace the rack:
1. Remove the rack by lifting it up and pulling straight out.
2. Replace the rack by holding it above the desired support and
pushing the rack back and down until it stops.
Adjustable Utility
Compartment & Tray
(on some models)
The utility compartment and tray slide from one side to the other
for more flexible storage. The tray fits on either side of the utility
compartment or partially underneath it. Try moving it to different
positions to find the option that works best for you.
To install the utility compartment and tray:
1. Insert the front of the utility tray into the slot on the back of
the shelf rail. Lower the back of the tray into position.
15

Advertisement

loading

  Related Manuals for Whirlpool ST21PKXJW00