Chapter 9 : Control Software - Analog way Smart Cut 2 User Manual

SMART CUT 2™

Chapter 9 : CONTROL SOFTWARE

9-1. CONNECTION
• CONNECTING THE RS-232:
• If you use the SMART CUT 2
- Connect the serial port of your Control Device (PC) to the REMOTE CONTROL (RS-232) connector (DB 9
Female) of the SMART CUT 2
• If you use the SMART CUT 2
- Connect the serial port of your Control Device (PC) to the REMOTE IN (PC) connector (DB 9 Female) of the
SMV415 with a straight cable (DB 9 Female / DB 9 Male).
- Connect the REMOTE OUT (CHAIN) connector (DB 9 M) of the SMV415 to the REMOTE CONTROL (RS
232) connector (DB 9 Female) of the SMART CUT 2
NOTE : The Remote Keypad (RK20) is not compatible when the SMART CUT 2
• If you use the SMART CUT 2
- Connect the serial port of your Control Device (PC) to the REMOTE IN (PC) connector (DB 9 Female) of the
SMA415 with a straight cable (DB 9 Female / DB 9 Male).
- Connect the REMOTE OUT (CHAIN) connector (DB 9 Male) of the SMA415 to the REMOTE IN (PC)
connector (DB 9 Female) of the SMV415 with a straight cable (DB 9 Female / DB 9 Male).
- Connect the REMOTE OUT (CHAIN) connector (DB 9 M) of the SMV415 to the REMOTE CONTROL (RS-
232) connector (DB 9 Female) of the SMART CUT 2
PC
NOTE: The Remote Keypad (RK20) is not compatible when the SMART CUT 2
SMA415.
™
alone :
™
with a straight cable (DB 9 Female / DB 9 Male).
PC
KEYPAD
RK20
™
with the SMART SWITCH VIDEO
PC
™
with the SMART SWITCH VIDEO
SMA
OR
S-CUT 2
™
with a straight cable (DB 9 Female / DB 9 Male).
SMV
™
with a straight cable (DB 9 Female / DB 9 Male).
SMV
Chapter 9 : CONTROL SOFTWARE
™
:
S-CUT2
™
is used with the SMV415.
™
and with the SMART SWITCH AUDIO
S-CUT 2
™
is used with the SMV415 &
™
:
PAGE 23