Tech Specs; Troubleshooting - Blizzard Lighting Wink Manual

Tech Specs!

Weight & Dimensions
Width
Depth
Height
Weight
Power
Operating Voltage
Power Consumption
Light Source
LED
Thermal
Max. Operating Temp.
Movement Range
Pan
Tilt
Control
Protocol
DMX Channels
Input
Output
Other Operating Modes Standalone, Master/Slave, Auto, Sound Active
Warranty

Troubleshooting

Symptom
Fixture Auto-Shut Off
Beam is Dim
No Power
Blown Fuse
Slow Movement
Fixture Not Respond-
ing / Responding
Erratically
Wink™ User Manual - Rev. A
8.3 inches (210 mm)
6.5 inches (164 mm)
12.1 inches (306.6 mm)
12.5 lbs. (5.7 kg)
100V-240VAC, 50-60Hz
110W, 1.44A, PF: .66
1x 60W RGBW 4-in-1 LED
8* 0.5W RGB 3-in-1 LEDs (Ring)
104 degrees F (40 degrees C) ambient
540 degree (8-16 bit resolution) / Infinite Pan
270 degree (8-16 bit resolution) / Infinite Tilt
USITT DMX-512
19/26 or 35-channel DMX modes
3-pin XLR Male
3-pin XLR Female
2-year limited warranty, does not cover malfunction caused by
damage to LEDs.
Solution
Check the fan in the fixture. If it is stopped or moving slower
than normal, the unit may have shut itself off due to high heat.
This is to protect the fixture from overheating. Clear the fan of
obstructions, or return the unit for service.
Check optical system and clean excess dust/grime.
Check fuse, AC cord and circuit for malfunction.
Check AC cord and circuit for damage, verify that moving parts
are not restricted and that unit's ventilation is not obstructed
Check that speed channels are set appropriately.
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fixture(s).
Page 18
(c) 2017 Blizzard Lighting, LLC