Table of Contents
Advertisement
System Utilities
Other utilities found within the control panel menu.
Display Timeout:
1.) Navigate the main menu until you reach Utilities, press <ENTER>.
2.) Highlight Disp. Setting <ENTER>, then Display Timeout <ENTER>.
3.) Set the timer to shut off the display after 2-60 minutes of inactivity.
Display Invert:
1.) Navigate to Utilities <ENTER>, then Disp. Setting <ENTER>.
2.) Use the <UP/DOWN> buttons to select Display Invert, press <ENTER>.
3.) From here, you can select Normal or Invert to flip the display.
Pan/Tilt Invert:
1.) Navigate to Utilities <ENTER>, then Pan Invert or Tilt Invert <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Normal, or Invert.
3.) Press the <ENTER> button to confirm.
Calibration Settings:
1.) Navigate to Utilities <ENTER>, then Calibration <ENTER>.
2.) Highlight either Pan, Tilt, or Zoom, and press <ENTER>.
3.) Make any adjustments needed, then press <ENTER> to confirm.
Fixture Test:
1.) Navigate the main menu until you reach Utilities, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select All (motors and LEDs), Pan & Tilt
(motors), LED (LEDs only), or Ring LED (ring LEDs only.)
3.) Press the <ENTER> button to confirm your selection.
Motor/Factory Reset:
1.) Navigate to Utilities <ENTER>, then Motor or Factory Reset <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Yes or No.
3.) Press the <ENTER> button to confirm.
Runtime Info
1.) Navigate to Utilities <ENTER>, then Time Info <ENTER>.
2.) From here you can view current Power On time, and Last Run hours.
Software
1.) Navigate to Utilities <ENTER>, then Software <ENTER>.
2.) From here you can view the installed software version information.
Wink™ User Manual - Rev. A
Page 13
(c) 2017 Blizzard Lighting, LLC
Advertisement
Table of Contents
