Operating Adjustments; The Remote Control; Setting The Dmx Address; Static Colors - Blizzard Lighting Motif Sketch Manual

4. OPERATING ADjUSTMENTS

The Remote Control

All the goodies and different modes possible with the Motif Sketch™ are accessed by
using the IR remote control (sold separately).

Setting the DMX Address

1.) To set the starting DMX address, push the
<S> button. You'll see the LEDs flash 3 times in a
sequence of colors that indicate the currently set
DMX address. For example, if the DMX address is
currently 001, the flashes would be white (zero)/
white (zero)/ red(one). (See static color table)
2.) Enter a 3-digit DMX address: 001-512.
3.) Now you'll see the LEDs flash 3 times per digit
you enter, and notably, they will flash the assigned
static color that corresponds to that digit. For
example, setting the fixture to the DMX address of
010, the flashes would be white (zero)/ red (one)/
white (zero). (See static color table)

Static Colors

To use fixture in static color mode, press either the
<R>, <G>, or <B> buttons, and then one of the numeric buttons (0-9). The color
table below shows the static color for each number.
Static color table
Button 0
White
Button 5
Cyan

DMX Mode

The Motif Sketch™ will automatically recognizes a DMX signal when connected to a
controller, and will function in 3-channel RGB color mixing mode. If the DMX signal is
lost, the fixture will revert to its previously set mode.
You can use the remote control while in DMX mode to switch to any other mode.
Then to return to DMX mode, press the <D> button.
3-channel DMX mode
Channel
1
2
3
Motif Sketch™ Manual Rev. A
Button 1
Red
Button 6
Blue
Channel Value
000 <-> 255
000 <-> 255
000 <-> 255
Button 2 Button 3
Orange Light Yellow
Button 7 Button 8
Purple
What it does...
Red Intensity (0 <--> 100%)
Green Intensity (0 <--> 100%)
Blue Intensity (0 <--> 100%)
Page 10
Button 4
Green
Button 9
Pink Yellow
Copyright (c) 2012 Blizzard Lighting, LLC