Setting Guidelines - ABB REL670 2.2 IEC Applications Manual

Section 20
Ethernet-based communication
20.3.2
20.4
20.4.1
20.4.2
808
IEC17000044 V1 EN-US
Figure 402: Merging unit

Setting guidelines

For information on the merging unit setting guidelines, see section
61850-9-2LE communication
Routes
Application
Setting up a route enables communication to a device that is located in another
subnetwork. Routing is used when the destination device is not in the same
subnetwork as the default gateway.
The route specifies that when a package is sent to the destination device it should
be sent through the selected router. If no route is specified the source device will
not find the destination device.
Setting guidelines
Routes are configured using the Ethernet configuration tool in PCM600.
Operation for the route can be set to On/Off by checking and unchecking the
check-box in the operation column.
Gateway specifies the address of the gateway.
Destination specifies the destination.
Destination subnet mask specifies the subnetwork mask of the destination.
IEC17000044-1-en.vsdx
protocol.
Line distance protection REL670 2.2 IEC
1MRK 506 369-UEN B
GUID-3449AB24-8C9D-4D9A-BD46-5DDF59A0F8E3 v1
IEC/UCA
GUID-19616AC4-0FFD-4FF4-9198-5E33938E5ABD v1
GUID-2C4A312A-00DC-44C8-B2D9-CD0822E1C806 v1
Application manual