Tools; Start-Up Kit Contents - Stratasys Fortus 900mc Operation And Maintenance Manual

TOOLS

START-UP KIT CONTENTS

The printer's Start-Up Kit contains the Welcome Insert document, software CD, the common tools you will need
to maintain the printer, and a variety of replacement parts. Use the following tables to identify the contents of the
Start-Up Kit.
Start-Up Kit Contents
Welcome Insert Document Contains instructions for downloading the 900mc User Guide (this document).
RJ45 Cable
Leather Safety Gloves
Protective Arm Sleeve
Magnetic Handle
Pick Set
Hex Ball
End
Driver
(9/64)
10x
Lighted Magnifier
5" Cutters
Needle Nose Pliers (7
Angled Tweezers
#2 Phillips Screwdriver
Platen Dusting
Brush
Scraper
Utility Knife
Insight CD
This cable is used to establish a network connection between the 900mc and your
Ethernet network. Job files are transfered to the printer via this connection.
Printer components may be extremely hot. To prevent burns or other injuries, these
gloves should be worn any time you see the gloves safety sign.
To prevent burns or other injuries, these sleeves should be worn in addition to the leather
safety gloves.
Occasionally, you may need to use these picks to aid in the removal of breakaway
supports or clearing debris which have accumulated on the head and/or tips.
This is used throughout the process of changing the printer's tips.
This tool is included to aid you with performing an XYZ Tip Offset Calibration which
requires you to view small toolpath relationships. Batteries for this item (2 C batteries) are
not included.
These are used to cut a canister's filament when unloading and removing materials from
the printer.
Occasionally, you may need to use pliers to aid in the removal of breakaway supports or
1
/ )
8
clearing debris which have accumulated on the head and/or tips.
This tool can be used for multiple general maintenance applications.
This tool can be used for multiple general maintenance applications.
This tool is used to brush away material debris when cleaning the platen. Always ensure
that the platen is clean before starting a build, as debris on the platen will affect vacuum
quality.
This tool is used to remove parts or debris from the build sheet.
This tool can be used for multiple general maintenance applications.
This CD is used to load Insight software (as well as FDM Control Center software) onto
your workstation PC. Insight is the software used to process files and then transfer them
to the printer to be built.
16