Frames R6I And R7I; Inverter Modules; Acs-Ap-X Control Panel - ABB ACS880-104 Hardware Manual

234 Ordering information

Frames R6i and R7i

Inverter modules


Deliveries of frame R6i and R7i inverter modules include the following items:
Ordering code
[Module type]
For example,
ACS880-104-0210A-3
[Module type] +C132
For example,
ACS880-104-0210A-3 +C132
ACS880-104-0210A-3 +C132
+F272
[Module type] +F272
For example,
ACS880-104-0210A-3 +F272
[Module type] +N8010
For example,
ACS880-104-0210A-3 +N8010
ACS880-104-0210A-3 +F272
+N8010
For module types, see Ratings
Note: The following components are also required to construct a working unit and must be
ordered separately:
•
An ACS-AP-W or ACS-AP-I control panel is required for the commissioning of an
ACS880 drive system, even if the Drive composer PC tool is used. See section
AP-x control panel
•
Common mode filters
The other parts listed in this chapter for these frame sizes
•
may be required by the application (such as a DC switch/disconnector), or
•
make the installation or use of the module easier.

ACS-AP-x control panel

The control panel is not included with the inverter module but must be ordered separately.
One control panel is required for the commissioning of an ACS880 drive system, even if
the Drive composer PC tool is used.
For more information on the control panel, see ACX-AP-x assistant control panels user's
manual (3AUA0000085685 [English]). See also sections
(page 43) and Panel bus (Control of several inverter units from one control panel)
167).
Contents
• Inverter module with ZCU control unit
• ZMU memory unit with ACS880 primary control program. For availability
of other control programs, contact your local ABB representative.
• Marine type approval. For more information, see ACS880 +C132 marine
type-approved drive modules and module packages supplement
(3AXD50000037752 [English]).
• Inverter module with ZCU control unit and internal charging circuit (note
that R7i requires additional external components – see page 235)
• ZMU memory unit with ACS880 primary control program. For availability
of other control programs, contact your local ABB representative.
• ACS880 primary control program with application programmability using
function blocks based on the IEC 61131-3 standard. For more
information, see Programming manual: Drive application programming
(IEC 61131-3) (3AUA0000127808 [English]).
(page 277).
below
– see page 240.
The ACS-AP-x control panel
ACS-
(page